George,
Slippery, from an engineering point of view would be called the
"coefficient
of friction".
We looked at many materials for zero contamination robots for wafer fabs
when I worked in Silicon Valley. We used a really easy way to test between
different materials. Make exact 1" square blocks out of steel or aluminum,
then coat them with the different surface treatments (leave one uncoated
for
reference).
Place them the edge of a piece of 1/4" thick, 12" square glass, the slowly
start picking up that edge of the glass. The part with the lowest
coefficient of friction will slide first. This test can be performed using
coated ground material instead of the glass to find the friction between
different coatings.
You must remember, that this has to be followed by a "wear test". In our
case, that really means beat the daylights out of an engine on the test
stand and then tear it down.
Larry
Thanks Larry,
I don't know if I will ever need to do that test on friction, but it is very
interesting none the less. I am an admirer of low tech testing, it appeals
to my simplistic mind.
The hardest part would be to make the exactly 1" square steel blocks, that
would drive me nuts.
BTW Larry, I'm still turning-up my single crank, on my cheap Chinese lathe.
I don't know how accurate it will end up, but the grinders will sort that
out. I was saying this to my Machinist neighbor that I will leave .5 for
grinding, he asked it I meant .5mm , I said .5" - that's a joke Larry, but
he was laughing like hell when he imagined me rocking up to the grinders
with 1/2" to grind off.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.