Subject: Apex Seal Sleeve & holding Clip
From: Rotary Engine
Date: 6/23/2008, 5:03 PM
To: AAA Put this in the To box


Paul,
I forgot to mention the holding clip arrangement, but Larry might have
better ideas.
George (down under)


George,
I would just drill it down the apex seal slot vertically and put a couple of
roll pins in.
Larry

Larry,
After considering the manufacturing implications, I can see your point
completely. I do consider mine more elegant though.

BTW I just cut a rotor down the middle, it was very easy to cut (no hard
parts) but it sure as hell isn't Cast Iron, I know it's cast, so it must be
cast steel.
Need a Photo?
George (down under)


I love to see the photos. What year was the rotor?

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.