Paul,
I forgot to mention the holding clip arrangement, but Larry might have
better ideas.
George (down under)
George,
I would just drill it down the apex seal slot vertically and put a couple
of
roll pins in.
Larry
Larry,
This is just a suggestion - after looking at the inner galleries of the
rotor, they don't appear to be too complex and I was wondering if the
rotors
could be done in two pieces and then friction welded together. The inner
passages could be done from stock material and the external finishing
completed after welding.
This would make for an interesting experiment.
Paul,
I don't know what year it is as it is a scrap rotor given to me from the
local engine rebuilders. I would image their pretty well much the same.
There's a lot of material in there around the bearing area. The fixed gear
pins can clearly be seen
George ( down under)
Thanks for the picture.
Well at least it is late enough to have twelve roll pins.
What is the rez on that camera? Was that a cell phone camera?
Paul Lamar
Paul,
It's just a cheap Sony Cyber-shop 2 mega pixels, not a phone camera.
Only nine roll pins must be an old one. I will look for a 12 pin to see what
differences there are.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.