Paul,
I looked at my Rx8 rotor and the measurements are the same for the pin
locations - except for the 3 identified in the attached drawing.
These 3 positions are exactly where there are positions for pins in the
'cut in half' rotor picture i.e. they just fill in the gaps.

So from this data, I can only assume the internal voids are exactly the
same for all rotors.
George ( down under)


I know that not to be the case. The RX8 rotor internals are different as is
the way they are cast. Also here is another cut away rotor picture.
Don't know the year. Last picture.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.