Hi Larry!
How did you pull out the spring pins?
Regards, Werner.

Years ago, I used to pull every third pin, then tap the hole with a 1/4-28
thread all the way down. Insert a grade 8 long set screw with red locktite,
and stake the top to prevent it from backing out. This is how we locked the
rotor gear from walking out of the rotor without having it snap ringed. I
was just too cheap to give my money to racing beat back then, and didn't
have my own machine shop to cut snap ring grooves!
We don't turn enough rpm to need this on the aircraft engines, but fun to
look in the rotors at the meat available for mods.
Larry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.