Subject: 2 place BD 5 kit?
From: Rotary Engine
Date: 6/26/2008, 12:32 PM
To: AAA Put this in the To box



Paul,   A few wks ago someone asked about the rotary in a 2 place BD 5.
Who is the kit manuf of the 2 place?  Was it someone in UK?  Can't seem
to find that web site.   Thanks,  Dave D


Here is the old message Dave.

One of the principles is on the list.

Sébastien  <sebastien.lefebvre@lhaviation.com>

What kind of engine do you have in there Sébastien?

Paul

-----------------------------
Any rotary powered BD-5s under construction or flying?

Jim Rudholm


Here is a similar all composite BD5 (2 seats) made by the French.  Would
love
to put a rotary engine in this one.  But can not afford it.  I think the
asking price with engine is 100 000 Euros, not sure.

Marc J.
http://www.lhaviation.com/site_frame/bases_marges/index.htm

http://fr.youtube.com/watch?v=UpmvstZuolA


Hello !

Directly copied from the site's english brochure :

"Concerning the propulsion, LH Aviation proposes the Rotax 912 ULS. It
develops 100hp
and it is cooled by liquid and air. Other alternative engine is under
consideration such as gas
turbine, turboprop and engines between 80 hp to 165hp."

Why not a rotary ?

Nevertheless, changing the engine means adapting the propeller shaft, and
one must be very
cautious about vibrations and vibration induced problems ( the tail control
surfaces are not very far !!!)

Philippe Dejean


The rotary vibrates less than a 912.

-- 
Paul Lamar ...No rotor no motor.


Dear all,

We choose the rotax 912s to put on our aircraft. The rotary engine is a good
choice for a pusher aircraft like we have. You reduce the problems of
vibration on the shaft. But I think, paul you can confirm, that you have
more temperature on the exhaust so it's not always easy to cool.

We are looking for rotary engine so we will see may be one day.

Regards


Sébastien Lefebvre

Président/ CEO

Aérodrome de Melun-Villaroche

77550 Limoges- Fourches

Tel: 01.64.87.19.07

www.lhaviation.com

Hang in there Sébastien. There are a couple of new
single rotors in the works. If Mazda based it would be 120 HP at 7500 RPM.
Exhaust is no problem if you use Inconel. If you use 321 SS you must
go up on the thickness to about .065" for close in work and thinner
as you get further out. Also try to keep the mufflers hollow
as anything inside is likely to be destroyed.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.