Subject: 2 place BD 5 kit?
From: Rotary Engine
Date: 6/26/2008, 10:44 PM
To: AAA Put this in the To box



   The problem for a two rotor driving a remote shaft is the same as
    > discovered by Jim Bede years ago. That is
    > torsional harmonics in the shafting system and the engine. At the
   time
    > it was a 2 cylinder 2 cycle engine with two power strokes per
    > revolution. Just like a rotary. Eventually overcome, but daunting at
    > first. Pulleys overheated. Brackets broke. Crankshafts broke, and
   so-on.
    > Super soft mountings became the rule. But that allows lots of
   movement.
    > The shaft acts like a bell, and happy at a number of frequencies.
   One of
    > the engineers wrote an explanation on it, but I cannot find it at the
    > moment.
    >
    > Another fix is a big heavy flywheel, but that cure was never used.
    >
    > Lynn E. Hanover

   Lynn,
   There has been an Australian Invention which is major improvements in
   universal joints, which would suite a application such as a long
   prop shaft,
   it eliminates all vibrations and misalignments from memory - just can't
   remember the name of it.
   George ( down under)


Great strides have been made since those problems surfaced. A high speed
movie of the engine in the problem RPM. A heat image at different RPM. A
line on the shaft and a strobe movie. A damped weight on the shaft like
the iron ring in rubber on a Chevrolet V-8. Molt Taylor's marble
sandwich absorber. Very low mass shafting (carbon fiber).

Still, the proper engineering applied first reduces the complexity of
any crutch that must be added. Decoupling mechanisms, soft connections
and similar must not convert too much energy into heat, lest they have
short lives. All powered shafting is a collection of torsion bars
(springs) and like the springs they are love to ring like a bell.
Allowing variations in torque into one end of a flexible shaft, can get
you some very unhappy results at the opposite end. You might find the
shaft slowing to nearly a stop, then accelerating to twice input speed
for part of a revolution. Everything is a Slinky looking for your frequency.

My race car idles at 2,200 RPM. It starts to sound odd below 2,000 RPM.
At about 1,700 RPM it shakes the straight cut gears in the transmission
so hard it is hair raising. Sounds like a giant blender full of hammer
heads. The engine has very little rotating inertia, (flywheel effect)
and the torque pulses are prominent.

Lynn E. Hanover


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.