Subject: 4 rotor from two 13b engines
From: Rotary Engine
Date: 6/26/2008, 1:54 PM
To: AAA Put this in the To box


   paul,

   Have you ever seen the write up of the 4 rotor engine
   built by granny's speed shop from two 13b engines. it
   was just a one off, they don't sell it, but apparently
   it worked flawlessly. he includes some details of how
   he made it but has never finished all the sections.

   I find it really interesting to see what you can do
   with some ingenuity and machine shop time. maybe the
   turbo compound rotary will eventually be built the
   same way.

   http://members.tripod.com/~grannys/4rotor.html

   http://members.tripod.com/~grannys/4rotorcoupling.html

   gary from midland

   Yes I have seen it but I am a bit skeptical on the shaft
   coupling. The front shaft of a 13B is reduced down.

   The Corvette 4 rotor was similar but it took power out
   between the engines.

   --
   Paul Lamar ...No rotor no motor.


I spoke with him on the phone. Very nice guy. Seemed very willing to
help out if you were serious about doing one (i.e. have all the parts
and ready to go). What is really interesting about the engine is he set
it up in a "big bang" setup which was very effective for him in terms of
engine response. He was underpowered against his comp but his engine
just acceled faster. The same people who make hayabusa v8s (powertec) in
england also offer big bang hayabusa engine for grass racing buggys that
are much faster than their normal hayabusa powered racers. Same deal
with F1 motorcycles with two stroke engines. I was planning on using a 4
lobbed coupler shaft (stoffel spline) on the thing I was planning so I
could try out both configs to see which would work better in the long run.


Rob Woods

The coupler is not the problem. The front of the 13B and RX8 e-shaft
on the back engine is the problem.
>
> Paul Lamar

I think it's likely possible to weld the e-shafts together to
eliminate the necked-down section (and obvious stress riser there).

There's plenty of material to work with to get a good weld.  Is there
room in the housing to add a (nicely radius'ed) doubler coupling - to
build strength at the joint (probably not needed)?  At least for
non-boosted applications.

There are lots of automotive stroker cranks that are welded to extend
the throws (though the best strokers obviously use custom castings or
forgings).

The downside I see is that the alignment through the engine (between
the two 13b's) may become somewhat more critical now that there
wouldn't be any movement allowed by the (now missing) joint.  Dowel
the sections together?

It would be fairly cheap to try.  I don't get the impression e-shafts
are hard to come by..


Matt-

I don't think welding will work either. The shafts diameters were designed
for a two rotor. I am amazed that people don't have trouble with the 3 rotor
e-shaft. The Le Mans four rotor never ran more than 24 hours at full power.
ANYTHING will work if you limit the HP and or for a short period of time.
Four rotor e-shafts are kind of easy to make comparatively speaking. Why ask for
all the problems of two..... two rotors coupled together?
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.