Here is a way of building a 4 rotor using a one pcs. E-shaft.
This center bearing was used by Curtis Wright and was a well
kept secret for 50 years until somebody acquired a Curtis Wright engine
and took it apart.
--------------------------------------------------------------------
Here is another way of doing it. This is similar to the bottom end of
a four cylinder Offenhauser engine. The blown Offenhauser Indy engine held the
worlds record for HP per cubic inch for a long while. The bottom end was
cannon proof. The entire shaft, main bearings and main bearing holders
were installed from one end of the engine.
"The four-cylinder Offenhauser engine was designed and initially produced
by Harry Miller, whose supercharged straight-8's dominated the Brickyard
in the Roaring Twenties. His shop foreman, Fred Offenhauser, acquired
the company in 1934. The four-cylinder engine made its debut under the
Miller brand in 1930, first won the "500" as a Miller in 1935 and first
carried Offenhauser's badge to victory lane in 1937.
In 270 cubic-inch form, and later at 256 inches, it won 18 consecutive
Indianapolis 500's from 1947-64."
I would love to have a picture of the bottom end but so far it has slipped
my grasp :)
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.