Here is a way of building a 4 rotor using a one pcs. E-shaft.
This center bearing was used by Curtis Wright and was a well
kept secret for 50 years until somebody acquired a Curtis Wright engine
and took it apart.
--------------------------------------------------------------------
Here is another way of doing it. This is similar to the bottom end of
a four cylinder Offenhauser engine. The blown Offenhauser Indy engine
held the
worlds record for HP per cubic inch for a long while. The bottom end was
cannon proof. The entire shaft, main bearings and main bearing holders
were installed from one end of the engine.
"The four-cylinder Offenhauser engine was designed and initially produced
by Harry Miller, whose supercharged straight-8's dominated the Brickyard
in the Roaring Twenties. His shop foreman, Fred Offenhauser, acquired
the company in 1934. The four-cylinder engine made its debut under the
Miller brand in 1930, first won the "500" as a Miller in 1935 and first
carried Offenhauser's badge to victory lane in 1937.
In 270 cubic-inch form, and later at 256 inches, it won 18 consecutive
Indianapolis 500's from 1947-64."
I would love to have a picture of the bottom end but so far it has slipped
my grasp :)
Paul Lamar ...No rotor no motor.
Paul,
I really like the 1 piece design with the CW bearing design. Barring
that the Japanese design with the double taper works best for me. My big
question is how do you do the build-up? Perhaps custom holder that keeps
the e-shaft centered on the middle iron? It would be tricky that is for
sure.
Bill Jepson
It was a complicated design. Each rotor and it's rotor housing and end
housing were stand alone entities held together by hidden tension bolts
You probably built it up like stacking pancakes and bolting the end housings
together with external nuts an bolts.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.