Lynn,
There has been an Australian Invention which is major improvements in
universal joints, which would suite a application such as a long
prop shaft,
it eliminates all vibrations and misalignments from memory - just
can't
remember the name of it.
George ( down under)
Great strides have been made since those problems surfaced. A high speed
movie of the engine in the problem RPM. A heat image at different RPM. A
line on the shaft and a strobe movie. A damped weight on the shaft like
the iron ring in rubber on a Chevrolet V-8. Molt Taylor's marble
sandwich absorber. Very low mass shafting (carbon fiber).
Still, the proper engineering applied first reduces the complexity of
any crutch that must be added. Decoupling mechanisms, soft connections
and similar must not convert too much energy into heat, lest they have
short lives. All powered shafting is a collection of torsion bars
(springs) and like the springs they are love to ring like a bell.
Allowing variations in torque into one end of a flexible shaft, can get
you some very unhappy results at the opposite end. You might find the
shaft slowing to nearly a stop, then accelerating to twice input speed
for part of a revolution. Everything is a Slinky looking for your
frequency.
My race car idles at 2,200 RPM. It starts to sound odd below 2,000 RPM.
At about 1,700 RPM it shakes the straight cut gears in the transmission
so hard it is hair raising. Sounds like a giant blender full of hammer
heads. The engine has very little rotating inertia, (flywheel effect)
and the torque pulses are prominent.
Lynn E. Hanover
Lynn,
Found it - Thompson Velocity Joint ( Glen Thompson.
George (down under)
That has no effect on the torsional resonance problem we are discussing above.
http://www.rexresearch.com/thompson/thompsnuj.htm
Ordinary U-joint speed the shaft up and down. Constant velocity
joints don't. There are a zillion out there. Every front drive
car in the world uses constant velocity joints in the front
drive system. BMW and Mercedes rubber cushioned versions use them
in the rear drive line as well as the rear axles.
http://en.wikipedia.org/wiki/Constant-velocity_joint
What IS needed is a torsional damper.
http://www.lo-rez.com/products.php?id=5
http://en.wikipedia.org/wiki/Torsional_vibration
http://www.epi-eng.com/mechanical_engineering_basics/vibration_intro.htm
Torsional dampers are found in aircraft engines built into the counter
weights on the crankshaft. The original O-470 in my Cessna had two.
When I bought a new O-470 from Continental I paid an extra $500
to get four. That changed the TBO from 1500 hours to 2000 hours.
Almost every car engine in the world has a torsional damper on the
front of the crankshaft.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.