Subject: Tabs and bolts
From: Rotary Engine
Date: 7/4/2008, 8:58 AM
To: AAA Put this in the To box




In this picture you see an old set of Indy car headers in Inconel. There
are no bends. Bends are formed of small pieces of flat stock pressed
into forms and welded. So even the outside of turns have the full
thickness of material. Workmanship is flawless. At the collector you can
see where the overlaping tabs have been ground off. On the waste gate
header you can see the doubled tab connectors still in place. There are
two straps on each tab.

Note the extensive effort to get all of the tube centerlines the same
length to the collector.

The bolts used are slightly smaller than the holes in the straps and
they are not tightened against anything, so as to allow some movement.
Note the pocket clip near the rear of the header that slips over a blade
sticking out of the tunnel coach-work that supports the header weight.
All parts are stainless.

Lynn E. Hanover




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.