> > Paul,
> >
> > I want to reuse the apex seals and side seals. What kind of thread
> locking > > compound to
> > you prefer for affixing the side piece to the apex seal?
> >
> > The thread locking compound I used, didnt worked out very well.
> >
> > Kind regards
> > Thomas
> >
> > Anerobic bonding adhesive is called out in the shop manual.
> > Loctite 312 and Primer NF (Trichloroethylene).
> >
> > AKA Super Glue. It must be surgically clean with acetone or MEK first.
> > -- > > Paul Lamar ...No rotor no motor.
> > Thomas,
> As Paul suggests, I have seen superglue used. The material has to be
> clean.
> You can't use a lot or it gets everywhere and you only need it on the
> joining faces. Once their stuck it's still fragile so " Handle with
care".
> Once the motor starts the initial movement breaks them loose and the
heat
> and oil washes away the small glue residue. You can actually hear the
> corner
> pieces click into place if you carefully turn over the motor by hand and
> listen for them.
> George (down under)

Paul and George,
thanks for your suggestions.
When I assembled the apex seals back in the apex seal grooves , the side
seals dropped down
too easily. I doubt the splice would have withstand the force of the long
apex seal spring.

Kind regards
Thomas

"side seals"? Do you mean the side piece?

Do you have a 3 piece apex seal or a two piece seal?

There is a device called an assist piece.

Also you put the springs in after the rotor is in the housing
and the apex seals are in the slot.

Download the shop manual from:
http://www.wankel.net/~krwright/cars/rx7/manuals.html
-- 
Paul Lamar ...No rotor no motor.

Sorry Paul,
my fault. I used a false term. I mean the side pieces. I have the 2 piece apex seals as I got a Renesis engine.

I got a workshop manual from Mazdatrix.
The side pieces came off when I temporary put the seals without springs into the slots in order to
verify that the slots of the corner seals were in line with the slots of the rotor.
I will give the superglue a try.

Thomas


They are not supposed to do that. Try super glue and get back to us.
Lyn Hannover has done this many many times so perhaps he has some advice.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.