Subject: powder coat removal?
From: Rotary Engine
Date: 7/8/2008, 6:07 PM
To: AAA Put this in the To box



            >     What takes powder coating off of 4130 tubing?
           Besides dynamite.
            >     Dave D
            >
            >     A sander? Sand blasting? Paint stripper?
            >     --
            >     Paul Lamar ...No rotor no motor.
            >
            > NITRO.
            >
            > Bill Jepson.

           The mere mention of nitro reminded me that the major source
           comes from
           China.
           They stopped shipping recently, and will not allow transport
           within or out
           of
           their country until some time after the Olympics.
           Anyone holding amounts of it, at present, has the ability to
           gouge racers in
           need.
           Another sad state of affairs.

           Archie

           Common methyl cloride stripper will remove it.  They have it
           at Home Depot.

           Steve Brazil



       Folks, please do not use any of the following ideas regarding
       stripping
       powdercoat. The best and easiest way is to go to AutoZone and
       buy a can of
       Aircraft Stripper. It is available very inexpensively and all
       you need is to
       apply it and put it in the sun for 20 min or so then scrap it
       off with scrapper
       or wire brush. CAUTION It is VVERY CAUSTIC. Make Sure you use
       Nitral gloves and
       have plenty of soapy water available to rise. Stuff works
       incredibly well. There
       is nothing else that will work.

       Good Luck, Doug Mueller


   Everyone reads their labels, right ? Zip Stip and many similar products
   are Metholine Chloride.... works very very good. Its not corrosive, but
   not good for your health, so wear the gloves.

   -dave

It's been a while since I've gone through my e-mails -- Sat link is down
-- but I just wanted to let people know a really good paint stripper is
EFS-2500 (Canadian product).  I'm not sure how it works on powder coat
(e-mail the manufacture), but other paint is works well.  The best thing
about it, you can use it on pretty much anything (fiberglass, wood,
metal) and it's not as dangerous as the other stuff

http://www.m-tc.com/efs2500_home.htm

Cheers,

Burck


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.