Subject: Ford Mass air flow sensor
From: Rotary Engine
Date: 7/12/2008, 11:13 PM
To: AAA Put this in the To box

Here is the Ford hot wire version of the mass airflow sensor.
About $10 bucks in a pick your own part junkyard.
You will need a special anti tamper screw drive to get it
out of the aluminum housings. If you buy the aluminum housings
it could cost you $80 as the junk yard recycles those.
Thank to Larry Childs for the pin out.

These are very sensitive to dust in the intake system.
In fact my Mercury Cougar would foul every year or
so even with an air filter. Had to take it out
and clean it with a tooth brush and acetone.
Took about five minutes. I suspect the filter was shedding
fiber particles. You could not see the particles with the naked
eye. I had to use a jeweler's loop to see the offending particles.

The OBD II check engine light would come on and the dealer
wanted $90 just to hook up his computer. Then he wanted
$300 for a new mass air flow sensor not counting labor.
I don't think that included the aluminum housing :)


Just about any hot wire sensor can be used as Bob is designing
an op-amp so the gain can be changed to tailor the unit to your
needs.

Testing this is going to be tough. Best thing is hold
it out the window of your car while doing 120 MPH :)
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.