Subject: Building a 555 EFI system. Step 2
From: Rotary Engine
Date: 7/13/2008, 7:32 AM
To: AAA Put this in the To box

One of the first things to do is simulate the signal from a
crank angle sensor. The 555 requires a negative narrow
pulse to trigger it. Most low cost signal generators put out
square waves or sine waves.  One needs to convert the square wave
to a negative going narrow 12 Volt pulse. This simple circuit will do
the trick. It works from 1000 RPM to 11,000 RPM.
---------------------------------------------------

Here is step 2.

R1 will be replaced by Bob's op-amp circuit with control from
a mass airflow sensor.

C1 is about .1 uf at the moment.
The scope is set to 10 msec per division so the positive output
pulse is about 9 msec long. Goes high. The bottom of the
screen is 0 volts. Lower trace.
Upper trace shows the negative going  trigger pulse.

The trigger is coming in every 40 msec or about 25 times
per second or 1500 RPM.

So far this is an extraordinarily cheap and simple EFI system.
In fact this beats the cost of an Ellison aircraft carb or a
$1000 Weber for that matter by a factor of half the cost.
That includes $200 or so for the four injectors.

Step 3 will be adding the FET and the injector.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.