Hey Guys,
I finally came across some pictures of how they do a stacked 4 rotor
setup that we have seen from Austraila/Japan. I would assume they are
doing a machined down stationary gear but don't know if it is some
collar around that gear or the gear itself. I am sure staring it awhile
it will become more clear. Whats funny is the money they are charging
for this machine service. Does any one have any specs of the station
gear tooth profile itself? Also anything on the metallurgy of the RX-8
gears?
Rob Woods
Very interesting Rob. Thanks for the pictures. I have always been curious about
that. It is the oil drain back that is tricky. I am guessing they are starting
with the rear stationary gear.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.