Hey Guys,
I finally came across some pictures of how they do a stacked 4 rotor
setup that we have seen from Austraila/Japan. I would assume they are
doing a machined down stationary gear but don't know if it is some
collar around that gear or the gear itself. I am sure staring it awhile
it will become more clear. Whats funny is the money they are charging
for this machine service. Does any one have any specs of the station
gear tooth profile itself? Also anything on the metallurgy of the RX-8
gears?
Rob Woods
Very interesting Rob. Thanks for the pictures. I have always been curious
about
that. It is the oil drain back that is tricky. I am guessing they are
starting
with the rear stationary gear.
Paul Lamar ...No rotor no motor.
Rob,
I've always felt that the best approach was to have stationary gears each
side of the rotor. This would eliminate the rotor cocking at combustion and
eliminate the wear on the opposite side, hopefully.
No machining costs are funny, in fact I find them extremely unfunny.
I would also be interested in gear specs - I understand that racing people
had the gears tip relieved and this is also part of the RX upgrade as well
as the gears being hardened from 1989 on ( I think).
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.