George,
That would seem to make sense but the rotor gear would have to be one
piece then and I don't know how that would work off the top of my head
seeing as the gear is larger than the ID of the bearing area. If they
two gears didn't phase/line up perfectly then I imagine that it would
cause more trouble then the stock setup. This also comes back to one of
my original questions. The weight of a rotor is a rpm limiting factor
because of the rotor bearing or the tooth loads of the gears or both???
I was led to believe that the gear teeth were the issue since you can
always battle hydrodynamic forces with more flow and pressure. Having
double gears would help solve this since you are getting more contact
ratio per rotor. Don't know how you would squirt the oil into the rotor
either at that point if you "close" the open windows. Reason I ask about
tooth specs and material type is that would be an easy part oto make out
of something much stronger if need be. I have real good connections with
Taylor Race Engineering and know what they use on their top dog gear
boxes and such.
Rob Woods
It is a bit of both but the bearing load is something you cannot do
much about other than making the rotor out of aluminum. Mazda fooled
around with different roll pin configuration and drastically reduced
the gear loads. In simple theory there are no loads on the phasing
gears. In practice there appears to be quite a bit and nobody is
quite sure where it is coming from :)
--
Paul Lamar ...No rotor no motor.
Rob,
Points taken - the rotor 'cooling jet' can be fed via the bering pressure
feed oil hole in the crank. You have to drill a hole or holes in the inside
bearing face of the rotor ( in the groove) - too easy! It's an option for
the single rotor engines.
What material does Taylor Race Engineering use?
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.