Paul,
Do you have a schematic for the Op AMp circuit? What kind of gain
are you looking for?
Joe Berki
Limo EZ
Yes we do. Bob White did it. We need a gain of two.
The 555 pulse varies from 1 msec to 9.5 msec
while the mass airflow sensor puts out 0 to 5 volts.
We will make the gain adjustable for tuning purposes.
Maybe one pot is all we need for leaning. The same pot that
changes the gain. The 20K feed back resistor would become the
leaning pot.
--
Paul Lamar ...No rotor no motor.
Bob, I was looking through my op-amp drawer and I found two dozen
TLC274's Are these about equivalent to the TLC272 ?
--
Paul Lamar ...No rotor no motor.
Hi Paul,
Yes, those are the 4 per package version in a larger package.
They'll work just fine.
On the question of richening the mixture, it is also possible to
get nonlinear gain from the op amp by playing around with the feedback
loop if that's found to be necessary down the line.
Bob W.
Thanks Bob.
What would a non inverting version look like?
--
Paul Lamar ...No rotor no motor.
You basicly switch your input and feedback circuits, and the
ground/reference circuit pins. One input is labled (+), and one (-) the
(+) is the non inverting input, and (-) inverting input.
Craig Smith
What is the theory on the use of the Zener diode?
--
Paul Lamar ...No rotor no motor.
On the inverting op-amp, the zener is just setting a reference
voltage. This is needed because the op-amp is being used in a single
supply mode. It beats having to have a - supply. The reference is
usually set by a resistive divider, but in most cases the op amp would
be used with a regulated power source. Having a power source that can
vary between 11 to 14 volts changes the bias which changes the output
voltage. Formula attached in previous email.
Bob W.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.