Has anyone TIG welded a turbo manifold ? Its not cracked, I just need
to close a port with a 1" square piece of steel stock and was worried
about cracking it. My thought was to grind the boarder of the stock to a
sharp edge and stitch weld it a little at a time with some air cooling
between so the thermal stress on the manifold would be minimal. Any
suggestions ? I understand the iron in a turbo manifold is a little
different from plain manifolds.
-dave
Jerry can probably do it for you Dave. He is not far from Michigan.
--
Paul Lamar ...No rotor no motor.
Dave,
Any competent welder should be able to weld cast iron - it's a matter of
heating the material before welding it to avoid cracking at higher temps.
George (down under)
Paul,
I would recommend taking it to a shop that does repairs on engine blocks.
They have the most experience on that kind of stuff. Just finished a
welding course at the local community college where we had a lengthly
discussion on welding cast iron. That was the instructor's recommendation
if you don't have the experience to do it yourself. According to the
instructor, he said all cast iron is not the same. Some of it welds better
than others. The block repair shops heat the heads and blocks to drive off
the oil and get them to uniform temps before welding. Hope that helps. Jim
Brewer
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.