Has anyone TIG welded a turbo manifold ? Its not cracked, I just need
to close a port with a 1" square piece of steel stock and was worried
about cracking it. My thought was to grind the boarder of the stock to a
sharp edge and stitch weld it a little at a time with some air cooling
between so the thermal stress on the manifold would be minimal. Any
suggestions ? I understand the iron in a turbo manifold is a little
different from plain manifolds.
-dave
If you have no prior experience, and wish to fill a hole,
tap it and put an iron pipe plug in it.
Braze welding would be the next solution if you insist on welding.
If, as you indicated, TIG welding is wanted, preheating and post heating
would be the proper method on cast irons.
You can strip the flux coating off of a high nickel CI arc rod and use that
as a filler when using the GTAW method.
Archie
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.