Has anyone TIG welded a turbo manifold ? Its not cracked, I just need
to close a port with a 1" square piece of steel stock and was worried
about cracking it. My thought was to grind the boarder of the stock to a
sharp edge and stitch weld it a little at a time with some air cooling
between so the thermal stress on the manifold would be minimal. Any
suggestions ? I understand the iron in a turbo manifold is a little
different from plain manifolds.
-dave
Jerry can probably do it for you Dave. He is not far from Michigan.
--
Paul Lamar ...No rotor no motor.
Dave,
Any competent welder should be able to weld cast iron - it's a matter of
heating the material before welding it to avoid cracking at higher temps.
George (down under)
Dave,
If Paul can find it in his archives, I did a posting on how we welded Paul's
RX8 housing that was broken, complete with pictures. Same process applies. I
use a ceramic hot plate to heat the part to above 500 deg. F, then leave it
on the hot plate while welding. The hotter you get the manifold before
welding, the better. When the welding is finished, cool the part slowly by
turning down the hot plate a little at a time. The parts must be perfectly
clean, and use Nirod filler. It's a special filler rod specific for cast
iron.
Larry
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.