Subject: welding cast iron turbo manifold
From: Rotary Engine
Date: 7/18/2008, 10:50 AM
To: AAA Put this in the To box


        >> Has anyone TIG welded a turbo manifold  ? Its not cracked, I
       just need
        >> to close a port with a 1" square piece of steel stock and
       was worried>> about cracking it. My thought was to grind the
       boarder of the stock to a
        >> sharp edge and stitch weld it a little at a time with some
       air cooling>> between so the thermal stress on the manifold
       would be minimal. Any
        >> suggestions ? I understand the iron in a turbo manifold is a
       little
        >> different from plain manifolds.
        >>
        >> -dave
        >>
        >> Jerry can probably do it for you Dave. He is not far from
       Michigan.
        >> -- >> Paul Lamar ...No rotor no motor.
        >
        > Dave,
        > Any competent welder should be able to weld cast iron - it's
       a matter of
        > heating the material before welding it to avoid cracking at
       higher temps.
        > George (down under)


       Paul,
       I would recommend taking it to a shop that does repairs on
       engine blocks.They have the most experience on that kind of
       stuff.  Just finished a
       welding course at the local community college where we had a
       lengthly
       discussion on welding cast iron.  That was the instructor's
       recommendationif you don't have the experience to do it
       yourself.  According to the

       instructor, he said all cast iron is not the same.  Some of it
       welds better
       than others.  The block repair shops heat the heads and blocks
       to drive off
       the oil and get them to uniform temps before welding.  Hope that
       helps.  Jim
       Brewer


   We've welded Cast iron in the past a few times [I do design work
   for a welding shop]. While pre-heating the casting is important,
   more importantly we've found, is the rate at which the casting is
   allowed to cool down. We've even gone as far as to 'post' heat
   the part to keep it cooling evenly.. and extend the cooling time..
   We also use lots of blankets on the parts to help them
   retain their heat over a longer cool down.. If it cools too quickly
   it will just re-crack on the weld.  I'm not sure how much faith I'd
   have in a part which operates at a fairly high temperature like an
   exhaust manifold being welded.. and not cracking at some
   future point. If there was some other way to get the same
   result [new manifold] I'd be inclined to go that route. [It's that
   same old.. we can't roll over to the side of the road if it breaks,
   kinda  thinking..]

   Fwiw..

   Jarrett


This isn't crack repair, it's flow diversion, right?

Can the block-off plate be mechanically fastened or trapped - possibly
in addition to welding - providing a fail safe?  Mill a recess for the
plate to sit in, and then pin it in place?  Does it need to really seal
well?


Matt-


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.