Subject: belt drive for the single rotor
From: Rotary Engine
Date: 7/31/2008, 4:16 PM
To: AAA Put this in the To box


Paul,  a few weeks ago, before Oshkosh,  I sent you plans for a belt
drive that was decidedly too heavy for our purposes (single rotor) but
hoping you could engineer a weight reduction program for it--after all
it  was designed for a two rotor.  I forgot to mention it when you
were here.  Did you have a chance to look at the plans yet?      Jerry


Not yet Jerry but here is a preliminary design.
It uses Kaydon Reali Slim bearings which cuts the weight.


Paul Lamar

What you have already done looks fantastic.  The thrust off set 8.15
inches can  be very useful, prop clearance, room over the top of the
engine, etc.
Jerry

Thrust off set is good for certain installations but for the most part
you are better off with a planetary as that leaves room under the engine for a cooling system.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.