Subject: belt drive for the single rotor
From: Rotary Engine
Date: 8/8/2008, 11:40 AM
To: AAA Put this in the To box


Paul,  a few weeks ago, before Oshkosh,  I sent you plans for a belt
drive that was decidedly too heavy for our purposes (single rotor) but
hoping you could engineer a weight reduction program for it--after all
it  was designed for a two rotor.  I forgot to mention it when you
were here.  Did you have a chance to look at the plans yet?      Jerry


Not yet Jerry but here is a preliminary design.
It uses Kaydon Reali Slim bearings which cuts the weight.


Paul Lamar


Paul,  have you had a chance to work any further on the single rotor
belt psru?  What you have shown so far looks like a weight reduction
break through.   Jerry

Yeb it is. Due to those slim section ball bearings for the prop shaft.
I am focused on getting the RX8 p-port engine running on my
prop dyno with the new analog cheap fuel injection system. I have a couple
of other secret projects in the works as well :)

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.