Subject: NA 20B dyno curve
From: Rotary Engine
Date: 8/10/2008, 5:20 PM
To: AAA Put this in the To box



Paul,


My SeaWind friend just got his all alumium (except for the intermediate
housing) 20B with aggressive street ports and slightly enlarged exhaust
ports back from R.B.  He is considering the new PowerSport PSRU as it
is robust and three inches shorter than Tracy's combination.  I don`t
particularly like the reduction ratio of  2.42:1 as it would difficult
with his 76" to take advantage of the top rpm power.  Unless he pushes
his prop rpm over 2700 on T.O.  his engine will be hovering around 6500
rpm which is below peak hp.  Redline on a 20B was I believe was around
8000 rpm but max power was below that figure.

Do you or anyone have a dyno curve on a NA 20B at 6500 to 7000 rpm?   My
rough guess would be around  270 - 280 Hp.

We know turbocharged it put out max 320 Hp. As a contingency plan he
will slap a turbocharger on it.

Doug in Japan


It all depends on the intake manifold. What I have is on Al Gietzen's
intake manifold which is less than optimum. Notice haw the manifold air pressure
starts to drop at 3000 RPM.

Paul Lamar

Paul--Al has done a great job but the data appears to again show the basic
limitation of side port configuration compared to a well configured
peripheral port arrangement.  We ran into this with the first prototype
engine which used dual side ports.  It made 200 hp @ 7,000 but the target
was that power at lower rpm for safety and durability.  We quickly realized
a ram tuned peripheral port would be much better by achieving the same h.p.
at a much lower rpm...same 200 h.p. was at 5,900 r.pm.

Steve Beckham.

------------------------------------------------------------------

I totally agree. I am amazed the sharp right angles in the side ports
makes so much difference. Apparently a lot of youtube viewers also
agree as we have had over 5350 hits on our youtube RX8 P-port "How to step by step". It is running about 100 new hits a day. By far our most popular youtube video. We discovered one can weld a SS tube to the steel liner real easy :)
Ironically Mazda themselves could do it with out affecting the EPA smog
rules if they did it with a trap door p-port like this.

http://www.youtube.com/watch?v=LkKw72dZ2yc

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.