> >>> Hi Paul,
> >>> Are the Hatch exhaust ports available anywhere or must one fab his
> own?
> >>> Also, is anyone building and selling an aluminum oil pan for the 20B
> >>> engines? I thought maybe Ed Klepeis was but I dont know how to reach
> >>> him. Can you help me contact him? Thanks much!!
> >>> John Bell
> >>>
> >>>
> >>> Hey Steve Beckham, do you want to build and sell those exhaust
> flanges?
> >>> Paul Lamar
> > >
> Paul and Steve,
> here was a thought I had on making a "spring" clamp to hold the ball
> flange on uncrushed. The material needs to be a tough enough steel that
> it would remain springy. This was a quickie effort, I hope that it is
> obvious as to function.
> Bill Jepson
Bill, thanks so much for the drawing. This is an interesting approach if we
could make it20thin enough to avoid the weight penalty. The neat thing
about
the approach is that the tension could be tested and altered by simply
changing the amount of the slot in the capture plate. Have you had any
experience with such pieces...whether they took a set in relaxed state
after
heating/cooling? Weight would appear to be down side of this approach as
the sheet stock would have to start out thick enough to CNC the female
portion (this was better part of 1/4" tall). Would effectively be doubling
up the number of flanges and related weight unless we put a lot more metal
on the floor to thin up portions of the plate after machining the female
part of the ball joint in the plate...or could refine the concept in
another
way. We were just using a press in the shop and pressing these out by hand
so it was simple, cheap and light. Good in those respects. But with your
approach we could CNC the female shape into the part and BBC steel up the
street can do the slots easily. I have been having a tough time lately
sourcing surplus Inconel flat stock..either 600 or 700 series and cost is
major issue also. If anybody has any suggestions about alternative stock
to use for this application, would appreaciating hearing. Bill, thanks
again for adding this approach to consider. And Paul, thanks for the
further information on your slide throttle. Very interested to see how it
operates in further testing.
Steve Beckham
Steve, thanks for your interest. Yes I have used that layout for
holddowns on semiconductor heaters in the past. We saw nil trouble at
400°C. That's about only 750°f though. You might need a material that
will tolerate the temperature. X700 or inconel would hold up better and
the flat plate would be easy to cut using water jet or laser. It would
be interesting to know what the actual temp of the plate. The gas stream
can easily see 1700°F at WOT in the center of the pipe but the flange
should be considerably less.
Bill Jepson
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.