Subject: Response regarding exhaust ports/flanges/joints
From: Rotary Engine
Date: 8/14/2008, 4:07 AM
To: AAA Put this in the To box


> > Steve, thanks for your interest. Yes I have used that layout for
> > holddowns on semiconductor heaters in the past. We saw nil trouble at
> > 400°C. That's about only 750°f though. You might need a material that
> > will tolerate the temperature. X700 or inconel would hold up better and
> > the flat plate would be easy to cut using water jet or laser. It would
> > be interesting to know what the actual temp of the plate. The gas
stream
> > can easily see 1700°F at WOT in the center of the pipe but the flange
> > should be considerably less.
> > Bill Jepson
>
>
>
> Thanks for the background Bill. Regarding your question about actual
> component temperatures, we never did measure the heat of the exhaust
flange
> and pipes accurately at different stations. But in the evenings with it
> getting dark, visually you could get a good picture of the highest heat
> sections during long dyno runs especially when the mixture was leaned
up for
> best power and EGT's would increase and stabilize @ 1700F. Because we
were
> spacing off the capture plate with AN washers to set preload on the
> balljoint, this had an obvious effect on reducing heat there but the
female
> portion of the ball joint was a portion at the most inboard assembly
closest
> to the fire and as you would expect, the ball joint portions at the port,
> portion of the flange and exhaust pipe for some distance would become
> translucent. Don't know if its is on their web site, but there is a photo
> which shows exhaust temperature in the Burns Stainless catalogue (p27)
> showing the BMW F1 engine at full tilt on the dyno and that system is all
> Inconel and looks the same far further downstream than
expected...past the
> collector. The slip joints and sensor bosses welded in the pipe are
> instructive as well. But we never got around to getting good numbers
of max
> temps of all pieces at different stations.
>
> Steve Beckham

Dear Mr. Beckham:

Thanks for the report on solving high temperatures, a report which comes
from the trenches of "Development Hell."  This may not sound like a
compliment, but it is: I love it, and find it extremely valuable, to
learn more about the rotary Wankel engine through your story of
developing an Aircraft Rotary Engine.  You are not a lemon, to be
squezed dry, but I personally welcome every "war story" you can write
about your development efforts.  You've been there, done that, and have
seen the elephant.  Your stories are most instructive, most valuable. :-)

Suggestion.  You wrote:

"in the evenings with it (was) getting dark, visually you could get a
good picture of the highest heat sections during long dyno runs,
especially when the mixture was leaned up for best power and EGT's would
increase and stabilize @ 1700º F."

Now, with today's higher-resolution photo-mainpulation tools and more
advanced software, could we take those photographs of exhaust system
during those revealing evening runs and map out which sections of the
exhaust system were hottest, which sections were not so hot, etc.?

Why?  So that we could build exhaust systems such that each heat region
has the properly engineered materials and geometry so that each section
could handle the heat and vibration most effectively.

Les Nordman :-)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.