Subject: cast iron welding report
From: Rotary Engine
Date: 8/14/2008, 8:05 PM
To: AAA Put this in the To box





Briefly, I asked about welding off a port on a side project that
distracts my from my plane building - a diesel implant to a 92' Caravan....

So, I got some ER70S2 TIG welding rod to weld the 1/4" tool steel plate
to the end of a runner. It is not even average for my welding jobs
because I was stitch welding it with 3 - 4 minutes cooling time between
welds. It would result in very low red glowing metal w/o shields. Again,
this is not a repair of a crack that is likely probogated well into the
casting.

Here are the photos:

-dave



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.