From: Rotary Engine <rotaryeng@earthlink.net>
Subject: Formula 1 rotary engine.
To: "AAA Put this in the To box" <rotaryeng@earthlink.net>
Date: Sunday, August 24, 2008, 12:13 PM
> I think a turbo compound small four rotor engine
running at 25,000 RPM
> with aluminum beryllium rotors would make a great
Formula 1 engine.
> Two Ferrari piston engine have blown up in the last
two
> Formula 1 races. Probably crankshaft fatigue. Formula
1 engines only last
> two races anyway.
>
> These numbers are for a large aircraft piston engine
running at only 2500
> RPM but you should get the idea.
>
> Let's assume for the moment the connecting rod,
the piston pin and the
> piston with the rings weighs seven pounds. They all
move the same way the
> piston does. Mr. Newton said, and he seems to be
right, force equals weight
> times G's. The three pound piston alone looks like
870 pounds to the rod in
> the form of inertial load. Mr. Connecting rod has to
push and pull that 870
> pound piston back and fourth once every .006 seconds.
As far as Mr.
> Crank-pin is concerned that seven pound collection of
parts looks like it
> weighs about 2000 pounds! 290 G's times seven
pounds is about 2000 pounds of
> inertial load. Mr. Crankshaft says "OUCH!".
>
> This is a simplification of course. The compression
and combustion pressure
> loads sometimes adds to and sometimes subtracts from
these inertial loads.
>
> Metal fatigue happens when the force and therefore so
too the stress
> repeatedly reverses on a part. The cylinder spacing,
rod length, rod journal
> diameter, main journal diameter and cylinder bore all
have a large effect on
> the fatigue life of a piston engine crankshaft.
>
> The beauty of the Wankel on the other hand is the
eccentric shaft is
> straight through yielding no concentrated stress
problems up through four
> rotors and maybe more. The loads on the eccentric
shaft are always in
> one direction. They do not reverse.
>
> Consequently the life of an eccentric shaft is not
> limited. The same thing can be said of the rotor. If
the wear of the
> seals and the sliding surfaces can be reduced to very
low levels then
> the life of the rotary could be 10,0000 hours or more.
There is some
> evidence that silicon nitride ceramic apex seals
moving on the chrome
> plated rotor housings may have a life of 30,000 hours.
>
>
> Paul Lamar
Isn't engine life in Star Mazda cars testament enough?
=D
-Chris
Should be enough for any clear thinking person :)
Of course Mazda rotaries have dominated endurance racing
off and on
for the last 30 years when they have not been severely
handicapped.
An $800 million a year Formula 1 development budget would
do wonders for the
rate of development of a turbo compound rotary
Paul Lamar
Paul
If .oo6S represents 180 degrees of crank travel, then 1 rev is .012S which is 5K
rpm. Or did I miss something?
regards, Robert
5000 RPM / 60 = 83.333 RPS Therefore it takes 1/83.3333 or .012 seconds
to make one revolution of 360 degrees of e-shaft rotation.
180 degrees .006 seconds. I forgot the question :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.