Paul (and Doug) A week or so ago the subject of how to keep the
oil pan
flange flat during welding came up. I have tried a lot of
different
schemes but what I am doing now works perfectly. The fixture is a
flat
piece 1/4 steel same size as the pan flange (15.25 x 12.75 in the
case
of the Renesis). On the bottom I have tacked some 1.5" angle
iron to
lift the steel plate off the table to facilitate clamping. You
will be
amazed at how light the clamping pressure need be. I started out
with
bolting the flange down all around, then I switched to heavy c-
clamps
but now all I use are spring clamps three to each side. One of the
pictures is of the finished product with the clamps removed. You
can
see that is lying flat, no problems. Jerry
Jerry,
Thanks for the info. I appreciate this info. So in application you
bolt
up the alumunium pan to the engine using the three mm steel backing
plates provided with the earlier 13B engines?
I ask because I just gave away and old engine and it used said
plates to
increase the clamping pressure. Considering that the ductability of
1/8" aluminum and pressed steel is quite different I am wondering if
it
is advisable to use them with the alumunium oil pan?
Nice welds by the way.
Doug in Japan
Doug, no I don't use the plates of which I was unaware of until now.
Just bolt the aluminum flange to the engine. The steel backing
plates
would increase the clamping pressure. Also, large area fender
washers
could be used to the same effect. Jerry
Thanks Jerry.
Doug
This photo shows the fixture a bit better. I think the reason the
oil pan flange resists warping is that it is very hard (T6). Jerry
Jerry, what is the weight of the finished oil pan?
Steve Beckham
Steve, the weight will vary a few ounces depending on the rear
bracket (if any). 5 lbs is a good average. Jerry
Jerry over does it a bit as he uses .125 inch thick material
for ease of welding while .065 would be plenty for the sides bottom
and front.
A 10 inch by 10 inch sheet of .125 weighs 1.25 pounds.
A .065 sheet would weigh half that of course but harder to weld.
The back panel should be .125 as that takes the stress of the rear motor
mount.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.