> Hi Paul and all
>
> I would appreciate some wisdom from you guys in relation to:
>
> 1. Gascolators - Are they fuel water separators? Is it advisable to
> have one
> in the system for Western Australian conditions?
> My apologies if this is a dumb question.
>
>
> 2. Firewall barriers.
> The Glasair Super II RG came with a 0.5 inch Fiberfax sheet and
> aluminum
> cover sheet. Is this current technology. I understand Fiberfax comes
> with
> some health warnings when working with the stuff?
>
> Cheers
>
> Steve Izett
> Galsair Super II RG Renesis 4 port
> Perth, Western Australia
>
> 1. Yes they are fuel water separators. Required on cert airplanes by
> the FAA here in the US I think. I know it does not rain out there
> very much but you never know you might fly someplace where it does.
> Darwin maybe.
>
> 2. Wear a face mask. I would use thin gage SS instead of aluminum for
> a firewall. The melting temp is twice as high. Take no chances with
> airborne
> fire. Worst thing that can happen to you by far.
>
> Paul Lamar
>
Howdy, Steve.
I, too, am building a Glasair Super II RG with a Mistral 2 rotor
Rotary. Nice to hear that someone else is taking the plunge. As for
the gascolator, many Glasair builders are using the Andair gascolator,
made in England. Use the big one, even though you don't need the flow
rate. The big one (I don't remember the model number) has an
automatic bypass valve in the event that the screen gets clogged.
Also, I'd check with the other Glasair builders to see what their
experience with the alum. cover has turned out to be. I believe that
the protection comes from the fiberfrax, not the aluminum. The
aluminum is just a cover for keeping the fiberfrax in place over the
long haul. And, yes, use a respirator.
You may want to consider subscribing to the Glasair list at
http://www.glasair.org
. Lots of very good airframe and construction information there.
Steve Thomas
Super II RG
If the weight penalty is low for SS I don't see the logic of sticking
with a material (aluminum) that has half to 1/3rd the melting
temperature.
What is your reasoning Steve? I had one cut at a local sheet metal
shop for my Kis Cruiser. It was cheap.
Paul Lamar
Thanks folks
As far as the choice between Al and Stainless. Glasair provides Al.
I suppose the only other positive of Al over Stainless would be drilling
holes etc.
Steve Thomas,
How are you doing, the last photo’s I saw of yours had no cowl.
Steve Izett
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.