Subject: low-profile oil filter adapter block
From: Rotary Engine
Date: 9/2/2008, 5:06 PM
To: AAA Put this in the To box


Hi all,
Does anyone have a design for a low-profile adapter block to attach to
the oil filter mount, so a remote filter can be installed? Just curious
to know if I am reinventing the wheel or not.
Thanks much,
John Bell


Some body may have one of those but I don't know who. Jerry Hey could build it.
Here are some pictures. I'll ask Al Gietzen where he got his.

Paul Lamar


Paul,

I will assume  the Renesis engine oil pump is significantly better
performing than the 1990? single turbo 13B if have.  So how can I
upgrade the oil pump performance in my engine?
One option is to modify and bolt on the Renesis front housing

Second question.   Racing Beat recommends when trying to boost a 13B to
power levels over 300hp that a second oil return line into the block be
added.  Where would this second line be tapped into?


Doug in Japan.


There is nothing wrong with the 13B oil pump.
Especially the 3rd gen model. The 3rd gen turbo  generated 280 HP stock.

You can actually reduce the oil temp by doing away with the right angle
from the pump out to the oil coolers. Some say as much as ten degrees. Any time you are pumping fluid through a right angle you are adding heat. I think this
is the right place on the front end housing  but you can tell by examining a front end housings as the internal oil passages are obvious. This is as direct out of the oil pump as you can get. Block off the old front cover outlet. Keep the front oil pressure regulator in the system.

Don't use a pipe tap on the cast iron block. Too easy to crack the block.
Use a straight thread fitting with o-ring. Keep it the same size as the ID of the oil cooler plumbing hose.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.