Subject: Initial fit of engine mount on 801
From: Rotary Engine
Date: 9/6/2008, 2:05 PM
To: AAA Put this in the To box

Received the engine mount / pan / s-beam on Friday; beautiful work! Made
it through shipping no problem.

Initial fit looks really good. All the mount holes line up, and the top
of the s-beam appears parallel with the fuse center line (calibrated
eyeball). The bottom mount brackets appear to fit fine. I'll need to
trim back the firewall diagonal stiffeners to position them.

I've had to flatten a side on all 4 washers. The top 2 needed about 3/16
taken off the bottom to allow alignment with the mount holes. The bottom
two needed about 1/8 taken off the lateral sides due to interference
with the formed supports. (pictures below).

The last problem is slightly more serious. The upper arms slightly
interfere with the nosegear strut support (2nd and 4th pictures). It's
enough that the strut support is visibly flexed on each end when the
mount is bolted in. I'm considering cutting a semicircular relief into
the strut support to allow clearance. I think 1/4 inch radius will be
sufficient, which is less than 25% of the width of the material there.
I'll have to trim the L-angle that's underneath too. Please give me your
opinions on this.

The 5th and final pictures show the distance between the firewall and
oil pan. Using the oil pan mount holes as a reference, it appears the
e-shaft pulley vertically clears the top of the strut support by 1/2
inch; horizontally protruding slightly over the top of it. There's a
chance the pulley will conflict with the nose gear strut as it travels
upwards while taxiing, but I think it will be OK due to the angle of the
firewall (strut travels up and back, away from the pulley).

Thanks for the hard work and generous contributions guys, I never would
have pulled off something this nice by myself.

--Kenny A.


Zenair did not make it easy to build a motor mount with all that
bracing on the outside of the firewall.

I would saw out four 1/2 inch thick spacers out of aluminum plate
and move the whole mount forward 1/2 inch. They can be any odd shape. What ever fits. Make the area of the spacer at least as large as the steel washers Jerry used. If there is a rivet head in the way drill a large dia. shallow hole in the back side of the alloy spacer to clear the rivet head. The rear mount strut will angle forward enough to accommodate.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.