Subject: Wanted really strong rotor cleaner
From: Rotary Engine
Date: 9/13/2008, 12:55 AM
To: AAA Put this in the To box


        I have some rotors I want to clean.
        I want something I can soak the rotors in over night and have
        them come out spotless. Rotor claning takes 75% of the time when
        over hauling
        engines.

        Please state the type and brand and what state you live in. Some
        cleaners
        are not legal in some states.


        Paul



    Paul,
    Find a local transmission shop that has a parts washing machine.  The
    detergent they use is ph buffered to prevent chemical damage to the
    metal.  They may let you wash your rotors in their machine.  The parts
    washing detergent works in a household dishwasher as well if it has a
    "pot scrub" cycle that gives extended wash/soak times (or you can
    disable the timer and control it manually).  Find a discarded dishwasher
    from a cosmetic kitchen upgrade and install it at the hangar.

    Aubrey

    Hey that sounds like a good idea. There are places around that sell
    used dishwashers.

    Does Fl have an restrictions on carb cleaners?

    Paul Lamar


Paul,
I used some liquid cleaner that I purchased at Auto Zone.  I think it
was called Super Purple cleaner.  Took the carbon deposits off pretty
well.

Mark S.


Thanks Mark.
Did it eat the rotor bearing?

Paul Lamar
Hi Paul;

Try Home Depot - Zep, Industrial purple degreaser + warm water.
Wear gloves as it will degrease your fingers too!  Although my holey gloves always leaked and my fingers are still attached.
 
A quick pass with a brass brush will remove most stuff even after a few minute soak. A dental pick/old side seal
works well for the really caked on stuff in the grooves. More soak or a few passes will help.

The Zep Industrial purple is probably a bit hard on the bearings in long soaks, although I have seen pics of rotors that were absolutely sparkling soaked overnight.

With slightly more work (say 15 minutes per rotor), I typically just rotate a rotor in a small tub with an inch or so of cleaner to keep solution off the bearings as I scrub.
No big deal if some get on the rotors for a few minutes.

Wash and Oil after cleaning.

Happy scrubbing wink.gif
Cary

I should add a few more comments
Your rotors look pretty clean already, very little caked on stuff - they
should come out nice with very little effort.
A pre-soak/wash with old engine oil (as in your tub picture) also seems
to help loosen any caked on carbon.
From what I have seen this stuff does not eat the bearings perse.  It
did dis-colour the surface a bit with a white-ish film/oxidation layer?
This solution may also remove the gold coloured anti-rust? coating on
the rotors in long soaks.  Most rotors I have seen have a blotched look
as the coating has come off in patches over the years.

Lynn, know what the coating is?

As I said, I have seen some pics of rotors left overnite come out spotless.

Cheers
Cary

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.