Here are some more overhaul tricks.
One of the big problems we had was getting the front nut off this
engine. It had an auto tx flywheel on it so it called for a special Mazda
tool to lock the counter weight. I made one out of a chunk of aluminum
3/4 by 1-1/2 bar stock or thick wall rect. tubing I had laying around.
Over all length was six inches with a ten mm hole in one end.
Once I got the e-shaft locked with this tool I tried using a 3/4 impact wrench
no less on the front 19 mm nut. No luck. I even soaked it in WD 40 for a few
hours. Still no luck. I jacked the compressor up to 120 psi and still no luck.
I finally put a 3 foot pipe on a 3/4 breaker bar and it broke loose with
a bang. It took two people to hold the engine stand from turning.
That nut appeared to be on there for twenty years. It is possible to do
a half ass over haul without taking the nut, e-shaft, front end housing or front
cover off the engine. That may have been what was done with this engine.
Also a couple of pictures of one of four seal boxes.
Make sure you dig out all the little springs under the seals using tiny jeweler
screw drivers. Working on the rotor seals is like working on a watch :)
Dang I forgot the pictures again.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.