Subject: Overhaul tricks not in shop manual
From: Rotary Engine
Date: 9/15/2008, 11:47 AM
To: AAA Put this in the To box


> Here are some more overhaul tricks.
> One of the big problems we had was getting the front nut off this
> engine. It had an auto tx flywheel on it so it called for a
> special Mazda
> tool to lock the counter weight. I made one out of a chunk of aluminum
> 3/4 by 1-1/2 bar stock or thick wall rect. tubing I had laying around.
> Over all length was six inches with a ten mm hole in one end.
> Once I got the e-shaft locked with this tool I tried using a 3/4
> impact wrench
> no less on the front 19 mm nut. No luck. I even soaked it in WD
> 40 for a few
> hours. Still no luck. I jacked the compressor up to 120 psi and
> still no luck.
>
> I finally put a 3 foot pipe on a 3/4 breaker bar and it broke
> loose with
> a bang. It took two people to hold the engine stand from turning.
> That nut appeared to be on there for twenty years. It is
> possible to do
> a half ass over haul without taking the nut, e-shaft, front end
> housing or front
> cover off the engine. That may have been what was done with this
> engine.
> Also a couple of pictures of one of four seal boxes.
> Make sure you dig out all the little springs under the seals
> using tiny jeweler
> screw drivers. Working on the rotor seals is like working on a
> watch :)
>
> Dang I forgot the pictures again.
>
> Paul Lamar


Hi Paul,

A suggestion for your box.  Apply the labels to the rear surface of the
wall versus the bottom.  They will remain clean and readable for a
longer time.

Marc Joseph

Great idea. Thanks.

I just put some parts in the vacuum former.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.