Particularly when air racing rotary
powered airplanes. BTW a P-port, 215 HP 2 rotor powered Velocity aircraft
averaged 205 MPH in a 500 mile cross country air race in Augast 2007.
We do know the two rotor Mazda engine will currently generate about 200 HP
continuously with out melting or cracking"
The full power metal temperatures in the hottest parts of the rotor
housing are
actually about 100 F below the typical air cooled aircraft engine.
Mark Steitle is currently running thermocouples in his three rotor...
rotor
housings and is reporting no excessive temperatures.
Paul Lamar
Paul,
Only 215 hp, what is restricting his hp, or is that all he wants?
The thermocouples appear to be covered in red silicone - wouldn't that
insulate the thermocouple from the heat to a degree.
George (down under)
That engine had a smaller intake pipe than the one you saw at my hangar
today and due to the gear box ratio used was limited to about 6000 RPM or so.
Here is a chart overlaying the two HP curves. We ran the engine on the dyno to
7500 RPM. The redline for the stock RX8 engine is about 9000 RPM.
Yes they are but they should still work to a degree :)
The silicone will eventually reach the temperature of the surrounding metal.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.