Subject: Wanted to buy used apex seals
From: Rotary Engine
Date: 9/25/2008, 10:03 AM
To: AAA Put this in the To box


I need a few used apex seal parts.
I am cleaning and reassembling an engine that is not very worn but I
am missing
a couple of triangular corner seals and some short apex seal springs.
These are for a 1989 to 1991 2 piece apex seal 13 B engine.
Not the three peice seals.

The apex seals are hardly worn. New specs are .315 inches high and
these seals
are all around .290 inches high. Many hours are left on these seals as
the low spec is .256. The engine does not justify new seals.
It won't be used in an aircraft. Let me know what you want in the way
of money.

BTW I will be using a complete set of Creavey Teflon encapsulated silicon
O-rings in this engine. http://www.creavey.com/

Paul Lamar

Hi Paul;

I literally have a pile.  How many triangular apex corner seals and
short apex springs - 3 each?

Cheers
Cary


Thanks Cary. Three each would be fine.
These look like after market 2mm seals as the split is
.15 inch in from the end. About 3.5 mm. As far as I can tell
Mazda never made anything like that. Perhaps they are Hurley seals.
Got anything like that?

Paul Lamar


Paul, I have not followed the apex seal issues closely in recent years so
have what is probably a stupid question....will the late model two-piece
apex seals fit in prior year late-model rotors?  It appears the two piece
seals would be easier to assemble and design better suited to higher rpm
range but have no experience with them.  And related...for longer sustained
rpm operation seen in aircraft what has been the experience regarding which
is generally recognized to be best cost-effective combination for apex
seals/springs/etc?

Steve Beckham

What happen was the three piece seal sounded like a good idea but it turned out to be a disaster. Once the slot wore a little bit and the seal wore a little bit it was not uncommon for the seal to roll out of the slot with rather catastrophic results. Also in the turbo 3rd gen engines people would up the boost which aggravated the problem. Then you had detonation and the resonant frequency of the seal could be excited resulting in a cracked apex seal.

Consequently Mazda went back to the two piece seal with the RX8 engine.
In the RX8 rotors the casting were changed to allow a deeper slot which in theory reduced the wear on the sides of the seals and the slot wear in the rotors themselves. Not that seal wear was a problem as it is rather common to see rotary powered cars with over 300,000 miles on them. about 500,000 kilometers. Currently Mazda supplies two piece seals for the older engines that are not quite so wide. The .315 inch number comes to mind. I do not recommend after market steel seals as there is a lot of junk out there that will tear up your rotor housings. The Mazda seals are far more sophisticated than they appear with special iron alloys, laser heating and liquid nitrogen chilling.

If you are building aircraft engines I would go with Iannette silicon nitride ceramic seals as they are head and shoulders better than the stock Mazda seals.
Apex seals run  500 F so the ceramic coef. of thermal expansion is much lower meaning the seals stay straighter at high power levels. That and the fact that wear is near non existent.

BTW the method of casting the RX8 rotors was improved as well. They are currently centrifugally cast. See the pictures I took at the engine factory.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.