I need a few used apex seal parts.
I am cleaning and reassembling an engine that is not very worn but I
am missing
a couple of triangular corner seals and some short apex seal springs.
These are for a 1989 to 1991 2 piece apex seal 13 B engine.
Not the three peice seals.
The apex seals are hardly worn. New specs are .315 inches high and
these seals
are all around .290 inches high. Many hours are left on these seals as
the low spec is .256. The engine does not justify new seals.
It won't be used in an aircraft. Let me know what you want in the way
of money.
BTW I will be using a complete set of Creavey Teflon encapsulated
silicon
O-rings in this engine. http://www.creavey.com/
Paul Lamar
Hi Paul;
I literally have a pile. How many triangular apex corner seals and
short apex springs - 3 each?
Cheers
Cary
Thanks Cary. Three each would be fine.
These look like after market 2mm seals as the split is
.15 inch in from the end. About 3.5 mm. As far as I can tell
Mazda never made anything like that. Perhaps they are Hurley seals.
Got anything like that?
Paul Lamar
I'm afraid I don't have any like that.
I think they are Hurley's:
http://www.hurleyrotary.com/tipseals.php
I think the Atkins seals were similar but had only a single spring.
I have often wondered if not having the pointy apex triangular piece was
easier on the
chrome and did not develop the characteristic groove on one side of the
housing
killing them prematurely.
Cheers
Cary
Dang I was just over there. I should have stopped in the see Emon.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.