Subject: Cooling design for a Renesis in a Glass Goose
From: Rotary Engine
Date: 10/11/2008, 4:52 PM
To: AAA Put this in the To box



Paul  the photos you included in the last message were the 13b engine.  I
presently have the Renesis engine flying.  Not satisfied with the cooling
system -- yet.  With the 13b engine, I would say that the cooling was
acceptable for my area (cool weather),  could not use full power for long on
takeoff.

A photo of the Renesis installation.   Notice the air flow restriction
behind the front rad. even without an alternator -- not much space for air
flow around the engine.

Rino


That prop extension you have on there is a real positive factor Rino IMHO. That moves the prop back away from the pylon which is a good thing aerodynamically.
In theory one could reduce the angle of the sides of the pylon and give
perhaps enough room to get some ducts down to feed the internally mounted
rads. The wing would have to be trimmed aft of the spar. What diameter prop are you running? Two blade or 3 blade?

BTW Sandy, here are a bunch of dwgs that might help you out. I am not sure where
these came from so whoever sent them thanks. Since it is a turbo it my be Rino dwgs.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.