I just found this paragraph in my new turbine book I bought in London.
"Gas Turbine Engineering Handbook" Boyce. Third edition. 2006
Here is the quote.
"The new gas turbines being designed for the new millennium are investigating
the use of steam as a cooling agent for the first and second stages of the
turbines. Steam cooling is possible in the new combined cycle power plants,
which is the base of most of the new high performance gas turbines. Steam, as
part of the cooling as well as part of the cycle power, will be used in the new
gas turbines in the combined cycle mode. The extra power obtained by the use of
steam is the cheapest MW/$ available. The injection of about 5% of steam by
weight of air amounts to about 12% more power. The pressure of the injected
steam must be at least 40 Bar above the compressor discharge. The way steam is
injected must be done very carefully so as to avoid compressor surge.
These are not new concepts and have been used and demonstrated in the past.
Steam cooling for example was the basis of the cooling schemes proposed by the
team of United Technology and Stal-Laval in their conceptual study for the U.S.
Department Of Energy study on the High Turbine Temperature Technology Program,
which was investigating Firing Temperatures of 3000 degrees F 1649 °q, in the
early 1980s."
I had already considered this in 2005 for the turbo compound rotary
when I found out it is being done in bottoming cycle power
plant gas turbines. I did the attached 3D to show how it could work.
This is a further increase in the efficiency of the turbo compound Wankel
engine. Might as well put all that exhaust heat to work.
Development of the R3350 Turbo Compound Engine 1954 SAE Transactions. I had no
idea, prior to 2005, when I first read this paper, that so much kinetic energy
was wasted by the exhaust valves in a piston engine turbo compound. Need I
mention yet again... the Wankel rotary has no exhaust valves ?
Paul Lamar
Here is all you need to know about axial flow turbines in four pages.
It is intense yet simple and takes a lot of study. I enhanced and enlarged the
crucial vector diagram from the book using Linux gimp because the editors
unfortunately scaled it down to fit on the book page. I am sure that angered the
author. I know it would anger me if I were the author.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.