Strangely enough.. it is 3D.. I just showed a top view of the
flow streams..
but it was/is actually the real 3D model. This case the model would
represent a 2d path as it's uniform vertically.. but I
could also use the software to do say the interior of a cowl..
Airflow in a Computer case.. etc etc..
The only trick is it has to be a 'part' file.. all one body.. no
multi bodies
or assemblies of parts.. It also has to be a closed volume..
basically you
just select one face and tell it the air comes in here.. select a
secondface and say 'air goes out here'.. and it does the flow path
betweenthe two faces inside the volume.... [interacting w/
everything between
the two faces].. the full version can do heat transfer, surface
pressuregradiants, flow induced harmonics [flutter] etc.. etc
I've seen full scale a/c modeled w/ it and the pressure gradiant on
the surfaces.. you can also take that pressure gradiant data and
use it on the FEA side of the software to check aerodynamic loading..
[cowls.. wings etc]..
I've got the mid level version of the FEA.. but in an industrial
fab shop
there isn't really too much need for Flow analysis :)
Jarrett
Do I need to do a full 3D of the goose? I can I almost have it.
It seems to be working with the rads. I could attach them to the
goose top
and bottom of that helps.
Paul Lamar
We could always try.. actually you'd only need to do 1/2 [split down
the center as we can assume it would have similar flow on either
side..] The more detail we get.. the slower it will run.. but thats ok..
At some point it's gonna die as I think we're pushing the limit's of
what it's intended for [the baby version anyway]..
Haven't got a chance to run it again.. yet..
Jarrett
I simplified it somewhat. Does this help?
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.