Subject: Cooling design for a Renesis in a Glass Goose
From: Rotary Engine
Date: 10/19/2008, 7:51 PM
To: AAA Put this in the To box



We could always try..  actually you'd only need to do 1/2 [split down
the center as we can assume it would have similar flow on either
side..]  The more detail we get.. the slower it will run.. but thats ok..
At some point it's gonna die as I think we're pushing the limit's of
what it's intended for [the baby version anyway]..

Haven't got a chance to run it again.. yet..

Jarrett

I simplified it somewhat. Does this help?


Paul Lamar

I think it worked faster.. here's a top view shot of it.. sorry this took so
long.. Our new Waterjet showed up this week so I had a busy weekend
getting it set up..

I'll run it at a few more speeds to see what it turns out..

w/ this run it appears there isn't enough negative pressure
behind the rad to pull the air thru w/ a bit more ducting it should
get more flow... I'd guess..

Jarrett

Wow! Great Jarrett. Shows the rad is working as a turning vane. The negative
pressure can be enhanced with an increase in rad angle. Thanks a bunch. This is
encouraging indeed. This may actually improve the flow into the prop.
If you get time please try it with out the rad. I also think a one inch
thick rad of larger dimensions will work great.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.