Wow! Great Jarrett. Shows the rad is working as a turning vane.
The negative
pressure can be enhanced with an increase in rad angle. Thanks a
bunch. This is
encouraging indeed. This may actually improve the flow into the prop.
If you get time please try it with out the rad. I also think a one
inchthick rad of larger dimensions will work great.
Paul Lamar
More to digest... the pic names call out there perameters..
I think we're getting some 'wall effect' w/ this model but... it's a start
anyway.
Btw, on the lower speed ones w/ no rad.. the bottom left corner is
developing
into a vortex.. it has ~1/3 of a turn in the model.. some place between
that
60mph and the 120 is the sweet spot.. at 120 it's totally turbulant back
against
the body after the max camber point..
HTH
Jarrett
Classic separation. Just as I thought. The Goose fuselage is way too stubby.
No wonder they have all those problems with the pusher prop. The pusher
prop is
operating in a nightmare aerodynamic environment.
The rads will kill two birds with one stone. Turning vanes and cooling.
Yes I did notice the wall effect. It could be moved out a bit.
the last thing to try is a one inch thick rad instead of the current 2
inches thick.
Thanks for doing this Jarrett. Half a dozen Goose builder should also thank
you.
Final adjustments in the real world can be made by moving the rad in and out
and changing the angle. Scott Getting's full scale pickup truck wind tunnel
will
tell the final tale.
Paul Lamar
It has occurred to me that one major modification that should help greatly
is a
longer and bigger canopy. Extend it right out to the nose of the aircraft.
That
will smooth the flow along the sides of the fuse. The boundary layer may get
thicker but that is the lessor of the two evils.
-------------------------------------------------------
On further thought move the existing canopy 18 inches further forward
and make up the back part with fiberglass or carbon fiber for stiffness.
Move
the hinges forward at the same time and notch the top of the fiber glass
part to
accommodate the hinges and a longer cowl. This will lengthen the engine
cowl and
give more room in the cowl for rads or ducts.
Then put flat side windows in the fiberglass back part to restore side
viability.
This would be cheaper and better than a whole new plexi canopy.
Paul Lamar
--
Note that all the completed pix show VGs all over the side of the pylon.
The manual says do not fly without these devices.
The additional space for radiators would definitely help. One might could
move the canopy forward a few inches, but 18" would require a new canopy
altogether. The seating, CG, instruments (which come up with the canopy
opening), and structure are some significant issues that would all
complicate moving the canopy forward.
I'm trying hard to get some good data on the pylon airflow.
Scott Gettings
Thanks Scott.
Please take some pictures of your pitot tube positions on the mock up.
Static pressure taps are nice but velocity rakes give a direct read out
of air velocity. Air velocity through the rad is the bottom line.
Also short strips of cloth taped to the sides of the mock up
with a small digital camera taking movies of them would
also help. Turn the camera on jump in the truck and take off :)
The rads, located where advocated, might reduce the need for
some of the VGs. Turning vanes accomplish the same ends as
VGs. They attach the flow that becomes separated.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.