Bill,
I gave up on having the casting house that was working on our stuff. I am
currently looking for a new source in northern ca, so if you know anyone,
let me know. I have picked up the molds for the bell housing, as they never
got around to casting it for us.
So mistral is not selling parts.... guess that leaves the door wide open...
Larry

Too bad they used to do good work for me until they apparently were taken over by a new owner or something.

Paul Lamar

Larry,
That's very poor performance on their part, is it the thickness of the cast
that they were concerned about.
Perhaps you can track down the previous owner - perhaps he has another shop
or can guide you in the right direction. The chaps in the industry usually
know their competition quite well.
George (down under)

George,
The wall thickness didn't bother them, but they are so busy doing turbo and
supercharger compressor housings as well as cylinder heads, that they just
didn't want to mess with small potatoes. I just wish they had told me that
before they held onto my molds for 5 months.....
Larry