>> Scroll down for new additional messages.
>
>> Larry, Paul,
>>
>> It seems Japan Inc. recognize this as well, because the real training
>> starts when the newbie enters the company.
>>
>> " A recent graduate of a MIT made his appearance at the corporate
>> office and upon meeting the president received a mop with the
>> instructions to clean the hallway floor. He complained "I can't do
>> this work, I was hired as an engineer." "Right," says the
>> president, "I forgot... you are a college grad." "Let me show you
>> how."
>>
>> One thought on turbo compounding and dynamic energy recovery. Why
not do
>> both? The race car
>> would have some lower BSFC and/or power merits on the straights and
>> coming out of curves but the T.C system does nothing to recover energy
>> upon braking. Looking at the compound rotary turbine and its connected
>> mass as a flywheel however, then perhaps braking could accelerate it
>> even more.
>>
>> The flywheel becomes the energy source and braking and a downsized
>> computer controlled engine the power sources. Brake wear is almost
>> eliminated, engine is way downsized and
>> run at its most efficient speed. The connection to the flywheel/turbine
>> from the engine could be mechanical with an over running clutch.
>>
>> And what would be the connection between the wheels and the flywheel?
>>
>> Hydraulics or electric? My bet would be on electric in-wheel motors.
>> The race car is a complicated study in total efficiency and not the
>> least of the challenges is overcoming air resistance, and maintaining
>> traction. In-the-wheel air cooled motors are a big plus for delivering
>> power and weight exactly were it is needed. Yes wire efficiency is not
>> as great as direct mechanical shaft connection but the car is not
>> battery powered, it is flywheel powered.
>>
>> Doug in Japan
>
>
> Adding unsprung weight is horrible for vehicle handling in bumps. Big
> hp electric motors are very heavy compared to light weight race
> wheels/tires. I think there's some multiplier that's commonly used
> for the evaluating the cost of unsprung weight - like 3:1
> unsprung:sprung. I suppose brakes could be made somewhat
> lighter/smaller if the motor reliability is good enough. I don't know
> what the offset would be.
>
> And then, you propose using another electric motor to transfer energy
> to-from the flywheel?
>
> Haven't we had this conversation?
>
>
> Matt-
>
> Check out the Michelin wheel hub motors that also contain active
suspension.
> jd
Like this?
http://blogs.motortrend.com/6292441/auto-shows/coolest-tech-at-the-mondial/index.html
95 lbs/corner, 70 lbs of which is unsprung. 70hp/corner. That's
actually pretty impressive, but it's still also pretty heavy. If they
didn't try to also include suspension within the hub, the unsprung
weight should be able to come down a bit..
The Voltage is priced at 297k Euros. Ouch. I guess neodymium is
expensive...
Matt-
What is so difficult about a inboard motor and brake? In the old ADF
Formula Ford, (which later became the Swift), they ran cv joints and
lightweight half shafts at each wheel. Inboard brakes up front, normal
driveshafts in the back. Slightly parts intensive but otherwise
simple. Far less unsprung weight than an in-wheel motor.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.