Subject: Electric motor in each wheel
From: Rotary Engine
Date: 11/25/2008, 5:24 PM
To: AAA Put this in the To box


    Scroll down for new additional messages.

   Adding unsprung weight is horrible for vehicle handling in bumps.  Big
   hp electric motors are very heavy compared to light weight race
   wheels/tires.  I think there's some multiplier that's commonly used
   for the evaluating the cost of unsprung weight - like 3:1
   unsprung:sprung.  I suppose brakes could be made somewhat
   lighter/smaller if the motor reliability is good enough.  I don't know
   what the offset would be.

   And then, you propose using another electric motor to transfer energy
   to-from the flywheel?

   Haven't we had this conversation?


   Matt-

Why put the electric motors at the wheels- make them sprung weight by
putting them inboard and using drive shafts like we do now with gasoling
motors.

Brian Trubee



Higher total weight (possibly), but yes, that's certainly an easy
choice for the back (existing powered wheels).  For the front, adding
drive shafts and u-joints (or cv joints) would be a significant
increase in weight..  Need them on the front so that braking can work
properly.  A front wheel drive Indy Car instead?  Wouldn't be the
first time..  The back wheels could run with normal brakes maybe -
since not that much braking effort is required in back.  More direct
likeness to the econo-boxes most of us are driving now.


Matt-


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.