> Anybody selling a 20B pusher mount?  My velocity airframe is
complete(!)
    > and i am gearing up for engine and instrument install.  Al Gietzen
    > modified a Franklin mount, but my welding skills are...subpar, to say
    > the least.
    >
    > Also, I have decided to go turbo, not supercharger.  What turbo did
Tom
    > Parkes use on his ES and what is the latest version of the
    > turbocalculator spreadsheet program?
    >
    > jeremy solomon
    >
    > Jerry Hey can build you a motor mount. Make a sketch of the
    > firewall hard point locations and the distance from the firewall
    > to the prop flange. We have a few designs but we need to double
check.
    >
    > Do you have your turbo and water cooling plumbing decided? You should
    > do that before a motor mount can be designed and built. Here are a
few
    suggestions. Do you have 3D drawing capabilities? If not I  suggest
making
    > foam mock ups of all the parts and located them before proceeding
with
    > the motor mount design. I'll do a 3D for free after you decide where
    > you want to put things and you have a turbo manifold and waste gate
    > chosen.
    >
    > Tom Parkes can answer the turbo question.
    >
    > Here is Dave Leonards turbo calculator but I am not sure it gives
    > you enough info to insure the turbine will live under aircraft
    conditions.
    > At least half a dozen car turbos have been destroyed so far.
    > You are much more likely to get the turbo to live if you use an
    > aircraft turbo. It's a long story but car turbo charger can be
    modified
    > to slow the turbine so they will live. Easier to find an aircraft
turbo
    > and use it.
    >
    > Paul Lamar


    Paul, are there excellent SolidWorks files available such as a
    tractor driven unit 13B that I could adapt to a super cub/Patrol
    frame?.  We have solidworks, and if there are some time saving work
    already done, I would provide feed back when a new or different mount
    would be drawn up.

    The drawings/modeling of the 20B for the pusher were good and made me
    think there was others already out there.

    Scott

    Sure Scott. The files are too big to email so I will set up a download
    area on the web site with a stp file.

    RV4's are about the right width so one of these might work.

    I'll take the RV4 landing gear tubes out.
    Give me a day or so.

    Paul Lamar

OK it is not as big as I thought so here is a stp file zipped
that will load into Solid Works.

Paul Lamar


This guy is advertising a complete 20b fire wall back setup for a Velocity:
Jim, Charlotte, NC ph 828.361.2621, email jcad@wnccl.com

Ernesto